snap-back

snap-back 基本解释

网络  回折失稳; 回跃; 跳回; 回弹

医学

重点词汇

• backa. 后面的 vt. 使后退, 支持 vi. 倒退, 背靠 adv. 向后地 n. 背部, 后面
• snapvt. 使突然中断, 猛咬, 争夺, 拉断, 使有啪啪声, 厉声说, 突然射击, 用快照拍摄 vi. 咬, 扑, 抓, 折断, 劈啪地响, 厉声说, 砰然关上 n. 猛咬, 猛扑, 劈啪声, 申斥, 快照, 活力, 一般时期的寒冷天气, 揿钮 a. 突然的, 装搭扣的 adv. 猛地 [计] 子网访问协议

snap-back 双语例句

1. 1、 It is illogical, therefore, to expect a full snap-back in the consumer sector in 2010 or 2011.
   因此，指望消费部门在2010年或2011年迅速、全面恢复，是不合逻辑的。
2. 2、 Similarly, the reason for lateral snap-back is that the recovery of lateral elastic strain is faster than the increase of lateral plastic strain.
   侧向回跳的原因是侧向弹性应变的恢复快于侧向塑性应变的增加。
3. 3、 Then, on the basis of work by de Borst R etc, the analysis of direct shear test is carried out and the condition of snap-back is given.
   受deBorstR等工作的启发，对直接剪切试件进行了分析，得到了快速回跳条件。
4. 4、 Ultimate load-carrying capacity of tensegrity based on the buckling of struts Study on snap-back instability of structure
   基于压杆失稳的张拉整体结构极限承载力跳回失稳研究
5. 5、 Similar to possible snap-back of axial stress-axial strain curves, axial stress-lateral deformation curves can exhibit snap-back behavior.
   与轴向应力-应变曲线可能出现的回跳现象类似，试件中部轴向应力-侧向应变曲线也可能出现回跳现象。
6. 6、 The vacuum snap-back thermoforming techniques of ABS resin, and the vacuum snap-back thermoforming technology, materials, equipments, molds and process charts are described in detail.
   介绍了ABS树脂的真空吸塑成型技术，详细阐述了真空吸塑工艺，并探讨了原料、设备、模具对工艺的影响及成型工艺条件的控制。
7. 7、 It is demonstrated by numerical simulation that the trade-off is superior to the devices using unlocalized lifetime control, the forward on-state voltage can be reduced by 0.6-1.4 V at the same turn-off speed, and it can avoid the snap-back phenomena of a
   数值模拟表明，该器件的tf～VF折衷关系优于采用非局域寿命控制的器件，在相同关断速度下其正向压降可降低0.6～1.4V，避免了阳极短路结构的正向快速返回现象。
8. 8、 In the vicinity of top and base of specimen, compressive stress-lateral displacement curve exhibits snap-back behavior ( Class II behavior) once peak stress is reached, owing to that the recovery of elastic strain is faster than increase of plastic strain
   在试样的上、下端面附近，由于弹性应变的恢复快于塑性应变的增加，因而，轴向压缩应力&侧向位移曲线出现了快速回跳现象。
9. 9、 Analysis of lateral deformation of rock specimen based on gradient-dependent plasticity ( II): size effect and snap-back
   基于梯度塑性本构理论的岩样侧向变形分析（II）：尺寸效应及弹性回跳
10. 10、 Fault rockburst I is snap-back due to shear strain localization
    断层岩爆是应变局部化导致的系统失稳回跳
11. 11、 Numerical simulation of influence of loading rate on deformation characteristics and snap-back for fault band and elastic rock system
    加载速度对断层-围岩系统变形及快速回跳的影响单轴压缩岩样轴向回跳及侧向回跳理论研究
12. 12、 Numerical simulation of formation process and snap-back for a fault band and elastic rock system
    断层-围岩系统的形成过程及快速回跳数值模拟