post-combustion
post-combustion是什么意思、post-combustion怎么读
读音：[pəʊst kəmˈbʌstʃən]
[poʊst kəmˈbʌstʃən]
post-combustion 基本解释
网络 燃烧后捕集; 燃烧后捕获; 燃烧后脱碳; 后燃; 燃烧后
重点词汇
- postn. 柱, 杆, 准星, 邮件, 邮政, 标竿, 职位, 岗位, 哨所, 兵营 vt. 张帖, 邮递, 公布, 登入帐, 使熟悉, 布置 vi. 快速行进 adv. 急速地 [计] 记入; 登记, 上电自检
- combustionn. 燃烧, 骚动 [化] 燃烧
post-combustion 双语例句
- 1、
China and Australia will test a post-combustion capture ( PCC) pilot plant in Beijing as part of a plan to cut carbon dioxide emissions from thermal power stations.
作为减少热电厂二氧化碳排放计划的一部分，中国和澳大利亚将在北京进行燃煤电厂二氧化碳捕集示范工程试验。 - 2、
The UK aims to be at the forefront of the push for clean coal, and the government has pledged to part-fund a demonstration plant based on post-combustion carbon capture technology.
英国意欲成为推进洁净煤的领先国家，英国政府许诺，为一家基于燃烧后碳捕获技术的示范厂提供部分资助。 - 3、
The coal-fired power plant in Dongying will use ammonia refrigeration technology, part of the post-combustion technology and over which Alstom has the exclusive right.
在东营的燃煤电厂将运用燃烧后捕集技术中的冷氨技术，这是阿尔斯通的一项独有技术。 - 4、
Abstract: this article systematically describes the theory of post-combustion for recovering off-gas heat in the EAF steelmaking processes; the actual results of post-combustion are introduced and the key operation points are described.
文摘：系统地论述了二次燃烧技术的理论与实践基础，介绍了实际应用效果，提供了操作工艺要点。 - 5、
New laws on NOx emission limits in the EU and USA are introduced. It focuses on new NOx reduction technologies, including advanced low NOx burners, overfire air, post-combustion techniques etc.
介绍欧美最新的排放标准以及满足这些标准的低NOx排放控制技术，包括新型低NOx燃烧器、过燃空气法和后燃技术等。 - 6、
Development and application of converter oxygen lance with post-combustion
转炉二次燃烧氧枪的开发与应用 - 7、
According to present of Angang 100t Finger Shaft arc Furnace ( FSF) steelmaking process, the paper analyzed the technique of scrap preheated and discussed the effect factor such as raw material preparation, oxide-fuel burner, post-combustion and deducts s
根据安钢100t带指形托架的竖式电炉（FSF）炼钢生产情况，分析了废钢预热技术，研究了钢铁料结构、二次燃烧、氧油烧嘴和除尘系统对该技术的影响。 - 8、
Consequently the post-combustion duration shortens and the fuel economics increases.
而且随喷孔总面积的增加，喷油持续期和燃烧持续期均缩短。 - 9、
In general there are three ways to control mercury emissions, i.e. combustion, pre-combustion and post-combustion mercury control.
汞控制技术一般分为燃烧前脱汞、燃烧中脱汞及燃烧后脱汞。 - 10、
Results suggest that the controlling of oxygen, residue carbon contents and catalysts will reduce the PCDD/ Fs formation in post-combustion zone of waste incinerators and finally will benefit to environment.
对氧、碳、催化剂等参数的控制可以减少焚烧炉飞灰在后燃区的二恶英生成量，减轻废弃物焚烧炉对环境造成的压力。 - 11、
Further, the special attention has been historically focused on post-combustion technologies, which can be widely applicable to the scale of the fossil fuel power plant maturely. But it is restricted because of high energy consumption.
CCS技术中的燃烧后CO2捕获技术发展成熟，可广泛适用于大规模的化石燃料电厂，而由于能耗较大，制约了其大面积推广应用。 - 12、
Using soot particle size distributions of post-combustion period in which soot formation stops, experimental in-cylinder soot oxidation rates of diesel engine in high temperature gas phase are calculated with a new method.
利用后燃期无新碳烟生成阶段的碳烟基本粒子粒径分布，结合一个新的计算方法，得到了柴油机缸内碳烟在高温气相中的氧化速率实验数据。 - 13、
Coal combustion can generate a large amount of carbon dioxide. The methods of the carbon dioxide capture and treatment include: Pre-Combustion Capture, Oxy-fuel combustion technology and the post-combustion Capture.
电厂中煤粉燃烧会产生大量的CO2，能源系统控制CO2的方法主要包括：燃烧前将其气化、氧/燃料燃烧技术以及燃烧后CO2回收。 - 14、
The conflicts between depletion of fossil and human demand for energy, as well as the impact of post-combustion on the environment has become one of the most serious problems in the 21st century.
化石能源的枯竭与人类对能源需求之间的矛盾以及燃烧后造成的环境问题已成为21世纪人类面临的最严峻的问题之一。